Monthly Archives: February 2019

Octoprint Autostart Script

My goal: add a startup script to adjust my camera’s settings on reboot. I own Logitech c920 and I use it to monitor my prints on a Ender 3 pro. The c920 has several controls that can be adjusted and the primary one I wanted to change was to turn off Auto Focus. See this… Read More »

Logitech c920 Octoprint Fine tuning

Fine tuning a c920 (or any UVC capable camera) for Octoprint streaming. Turning off Autofocus. Using manual focus. Adjust contrast, etc. Note: When you get around to adjusting your controls, watch your stream to see the results and dial it in how you desire. Write down your values and then you can then use them… Read More »